Desa E18N Owner's Manual page 18

INSTALLATION
Continued
2. Rest middle log (#2) behind metal posts on front
burner. Make sure the grooves in the bottom of
the log fit over the grate. Bring the log forward
next to the metal posts. The cutout in the middle
log must be on top (see Figure 22).
3. Slide the grooves in the back of the rear log (#3)
against the rear grate prongs. Make sure the peg
on the log is on top (see Figure 23).
4. Place the crossover log (#4) on the back log and
the middle log. Make sure the peg on the rear
log is in the hole in the bottom of the crossover
log. The crossover log should fit in the cutout
of the middle log (see Figure 24).
Notch
Grate
Prongs
Metal Grate
Bar
Figure 21 - Installing Front Log (#1) [18"
Variable Manually-Controlled Set Shown]
Groove
Metal
Post
Metal Post
Figure 22 - Installing Middle Log (#2) [18"
Variable Manually-Controlled Set Shown]
Note: Your appliance may vary from model shown
but log placement will be the same.
18
Front Log (#1)
Middle Log (#2)
Groove
Grate
www.desatech.com
Groove
in Back
of Log
Grate Prong
Rear
Burner
Figure 23 - Installing Rear Log (#3) [18"
Variable Manually-Controlled Set Shown]
Cutout
Figure 24 - Installing Crossover Log (#4)
[18" Variable Manually-Controlled Set
Shown]
Peg
Rear Log (#3)
Groove
in Back
of Log
Grate
Prong
Crossover
Log (#4)
Hole
Peg
104415-01M