Desa E18N Owner's Manual page 14

INSTALLATION
Continued
IMPORTANT: Hold gas regulator with
wrench when connecting flexible gas hose
(Variable Manually-Controlled and Thermo-
statically-Controlled Models Only).
2. Locate mounting brackets, bolts, and nuts in
hardware package (Variable Manually-Con-
trolled and Thermostatically-Controlled Models
Only). Attach mounting brackets to heater base
(see Figure 13). Attach nuts finger tight.
3. Position heater base assembly in fireplace.
4. For Variable Manually-Controlled and Ther-
mostatically-Controlled Models mark screw
locations through holes in mounting brackets
(see Figure 13). For Remote-Ready Models
mark screw locations through holes in front
panel of base (see Figure 14). If installing in a
brick-bottom fireplace, mark screw locations
in mortar joint of bricks.
5. Remove heater base from fireplace.
6. Remove mounting brackets from heater base
(Variable Manually-Controlled and Thermo-
statically-Controlled Models Only).
7. Drill holes at marked locations using 3/16"
drill bit.
8. For Variable Manually-Controlled and
Thermostatically-Controlled Models attach
mounting brackets to fireplace floor using
masonry screws provided in hardware pack-
age (see Figure 13). Reattach heater base to
mounting brackets (see Figure 13). Tighten
nuts firmly.
Mounting
Bracket
Mounting
Screw
Bracket Nut
Figure 13 - Attaching Heater to Fireplace
Floor (Variable Manually-Controlled and
Thermostatically-Controlled Models
14
Masonry
Screw
Mounting
Bracket
Only)
www.desatech.com
Masonry Screw
Figure 14 - Attaching Base to Fireplace
Floor (Remote-Ready Models Only)
104415-01M