KVH Industries TracVision 6 Technical Manual page 37

5. Repeat Step 4 for each of the following
transponder categories:
• vertical high
• horizontal high
OR
• right
TracVision 6 requires that the data fields for all
transponder categories be provided. If the selected
satellite does not have information for one or more of
the transponder categories, default information should
be entered in the fields as follows:
Transponder Data
Frequency
Symbol Rate
FEC Code
Network ID
Polarity and Band
ZAP<cr>
6. Type
7. If you need to configure a second user-defined
satellite, repeat this procedure starting with Step 1
to enter data for the USER2 satellite.
You have now added your user-defined satellite(s) to the
system's satellite library.
If you want the antenna to track one or both of these user-defined
satellites, you will now need to install it. To install a satellite, use
the SATINSTALL command, as described in "Installing Your
Satellites" on page 36.
The next two pages provide examples of the user-defined satellite
configuration process.
54-0166
• vertical low
• horizontal low
• left
Default Value
00000
27500
the same value as provided for those
transponders with data
0x0000
whichever combinations are not
already provided
to restart the antenna.
Table 2-10
Satellite Transponder
Default Data
Installation
33