Electrical Adjustment - Sanyo VPC-CG10BK Service Manual

3. ELECTRICAL ADJUSTMENT

3-1. Table for Servicing Tools
Ref. No. Name
J-1 Pattern box
J-2 Calibration software
J-3 Chroma meter
J-4
Spare lump (pattern box)
J-5 Discharge jig
J-6 Collimator
J-7 Spare lump (collimator)
J-8 Siemens star chart
Download the calibration software and the firmware
from the following URL.
http://www.digital-sanyo.com/overseas/service/
Place the DscCalDi.exe file, camapi32.dll file and
QrCodeInfo.dll file together into a folder of your
choice.
J-1
J-4
J-8
3-2. Equipment
1. PC (IBM®-compatible PC, Windows 2000 or XP or Vista)
3-3. Adjustment Items and Order
1. Lens Adjustment (Infinity)
2. Lens Adjustment (1m)
3. AWB Adjustment
4. CCD White Point Defect Detect Adjustment
5. CCD Black Point And White Point Defect Detect Adjust-
ment In Lighted
Part code
Number
1 VJ8-0190
1
1 VJ8-0192
1 VJ8-0191
1 VJ8-0188
1 VJ8-0260
1 VJ8-0282
1
J-3
J-5
Note: If the lens, CCD and board and changing the part, it is
necessary to adjust again. Item 1-5 adjustments should be
carried out in sequence.
3-4. Setup
1. System requirements
Windows 2000 or XP or Vista
IBM® -compatible PC with pentium processor
USB port
40 MB RAM
Hard disk drive with at least 15 MB available
VGA or SVGA monitor with at least 256-color display
2. Pattern box
Turn on the switch and wait for 30 minutes for aging to take
place before using Color Pure. It is used after adjusting the
chroma meter (VJ8-0192) adjust color temperature to 3100
± 20 K and luminosity to 900 ± 20 cd/m
dling the lump and its circumference are high temperature
during use and after power off for a while.
3. Computer screen during adjustment
Calibration Upload
AWB
Firmware
Focus
Data
UV Matrix
Cal Mode
PAF Cal.
OK
EVF VCO
Cal Data
LCD Type
OK
USB storage
Get VID
PID
Set
Backrush pulse :
Get
3-5. Connecting the camera to the computer
This camera requires a DC adaptor (sold separately) in or-
der to use an AC adaptor.
1. Insert the DC adaptor to the camera.
2. Insert the AC adaptor's cable to DC terminal of the DC
adaptor.
3. Line up the arrow on the cable connector with the notch on
the camera's USB port. Insert the connector.
4. Locate a USB port on your computer.
5. If "USB CONNECTION" is displayed, choose the "COM
PUTER", and press the SET button.
Next, choose the "CARD READER", and press the SET
button.
- -
17
. Be careful of han-
2
LCD
R Bright
B Bright VCOMDC
RGB Offset Gain VCOMPP
Tint Phase
H AFC Test
Setting
Language
Set Serial
Set
Video Mode
Set Rev. Set
Factory Code
Set
Hall Cal.