Renkus-Heinz VARIAi VA101i-7 User Manual page 5

VARIAi arrays are easy to assemble and require very few parts and associated tools. All user hardware are M8 bolts. Simple arrays can be assem-
bled with no extra parts required as each enclosure comes with one set of connectors (MPS for 22's and 15's; SUB connector for VA15S; choice of
MPS, M1, or M2 con-nector for 7's). All VARIAi hardware is constructed of 16ga. zinc plated 1008 steel which is then powder coated. Powder coated
304 Stainless Steel versions of all hardware are provided with the WR models. All versions come in black, white, or can be custom colored.
The hole patterns on each connector serve different purposes. Each MPS connector has six holes that are used strictly to connect enclosures
together. The M1 and M2 multi-angle connectors have 18 holes (3 sets of six) that provide three different angle connections between 7° enclosures.
The diagrams below illustrate the design purpose of the remaining five holes. Four holes are used for direct connection to 1/4" shackles and suspen-
sion means for small arrays. The center rear hole is used to connect the REAR PICK BAR described later.
All VARIAi modules utilize the same basic internal structure which
includes encapsulated steel plates within each side wall in a sandwich
scheme. The inside steel plate includes captive locking PEM nuts that
accept the M8 stainless steel screws provided. Each module includes
12 of these screw positions and this provides a framework for easy
and safe arrays. Once configured, the array side walls become a steel
superstructure.
Modules are connected to each other with connecting plates. The most
common is the MPS CONNECTOR which creates a 'tight pack' con-
nection from module to module and is the typical connection used in
Modular Point Source arrays. The drawing to the right demonstrates this
connection and 'reveals' - for purposes of explanation— the MPS
CONNECTOR which is normally hidden.
Note: 15° and 22° modules only connect with the MPS CONNECTOR.
RHANG-VA101i
RHANG-VA101iH
RHANG-VA101i
VA101i-CN-MPS
VA101i-CN-RPK
1/4" SHACKLE PICK POINT
M8 SCREW
1 of 12 Per Enclosure
Warning:
The actual rigging of loudspeakers suspended from a
truss or from a ceiling is a serious undertaking that is
beyond the scope of this document. It should be done only
by qualified and experienced professionals using only load
rated hardware.
We strongly recommend that you have your design
reviewed and approved by a licensed structural engineer
who can also verify the suitability of the building
attachment points.
Renkus-Heinz is not responsible for any non Renkus-
Heinz products or for any misuse of Renkus-Heinz
products.
Point Source Array Modules
REAR PICK BAR
CONNECTION
i
5