Abit AT6 User Manual page 20

2-14
2
3.
Slide the clip (A) on each support toward the processor , exposing the
hole that will fit the peg on the mainboard . Push the latches (B) on the
processor toward the center of the processor until they click into place.
4.
Hold the processor so that the fan shroud is facing toward the pegs on
the mainboard. Slide the processor ( Direction C ) into the retention
mechanism and press evenly and gently. Ensure that the pegs on the
mainboard slide into the holes in the heat sink support and that the
alignment notch in the processor fits over the plug in Slot 1 .
Chapter