Jumper And Switches - Abit AT6 User Manual

Installing the Mainboard
11
® Jumper and Switches
You can set jumper switches on the mainboard to configure various hardware
options. See Figure 1-1 for jumper locations.
Throughout this section, the following symbols are used to indicate jumper
settings.
For 3-pin jumpers, the symbols below are used:
For 2-pins jumpers, the following symbols are used:
Note: To avoid losing jumper caps, attach the removed jumper cap to one of
the jumper pins.
Short Pins 1 and 2 with a jumper cap.
Short Pins 2 and 3 with a jumper cap.
Place the jumper cap over the two pins of the
jumper to Short the jumper.
Remove the jumper cap to Open the jumper cap.
2-