Printer Mechanism - Epson Stylus CX3700 Service Manual

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850

4.4.8 Printer Mechanism

External view (1)
Tabs
Rear Cover
C.B.P. 3x10 F/Zn
(4±1kgfcm)
Housing, Lower
Carriage Lock
Figure 4-11. Removing Printer Mechanism (1)
DISASSEMBLY/ASSEMBLY
Waste Ink Tube Red Line
Eject Ink
Tube Clump
Joint
Tab
Carriage Unit
Printer Section
Part/Unit that should be removed before removing Printer Mechanism
Document Cover / Paper Support Assy. / Scanner Unit / Panel Unit /
Housing Upper
Removal procedure
1. Remove the screw (x1, ) that secures the Rear Cover, and remove the Rear
Cover.
The Waste Ink Tube may be broken when it is removed.
C A U T I O N
If it breaks, replace the Ink System Unit.
Ink may leak from the Waste Ink Tube. Prepare cleaning rags
beforehand, and be careful not spread ink onto surrounding
area.
C H E C K
When removing the Waste Ink Tube, insert a plastic tweezers or a
P O I N T
similar tool between the rib of the Eject Ink Joint and the Waste
Ink Tube, and pick up the Waste Ink Tube.
Remove the Eject Ink Joint from the Housing, Lower, grasp the handle of the
2.
Tube Clamp and slide it upwards, and carefully remove the Waste Ink Tube
(of the Ink System Unit side).
3. Release the Carriage Lock with a flathead screwdriver, and move the Carriage
Unit to the center of the printer.
Revision A
104