Epson Stylus CX3700 Service Manual page 103

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850
When installing the Printhead to the Carriage Unit, match the
guide pins (x2, ) of the Carriage Unit with the positioning
holes (x2) of the Printhead.
Tighten the screws in the order as shown in the figure.
When installing the Sub FFC Guide, insert the rib of the Sub
FFC Guide to the notch of the Carriage Unit as shown below.
Figure 4-10. Installing Sub FFC Guide
A D J U S T M E N T
After removing/replacing the Printhead, perform the adjustment in
R E Q U I R E D
the following order. (Refer to Chapter 5 "ADJUSTMENT")
1. "PG Adjustment"
2. "Ink Charge" (only after replacement)
3. "Head ID Input" (only after replacement)
4. "Head Angular Adjustment"
5. "Bi-D Adjustment"
6. "First Dot Adjustment"
DISASSEMBLY/ASSEMBLY
Rib
Printer Section
Revision A
103