Sensor Mapping - Rayvision 8-Channel User Manual

NOTE
3.6.4.1 Record Detection Activate
This feature makes the whole setting of sensor setup is efficacious and system will log
the sensor triggered event even the DVR under the "Time Recording" mode.
Enable: Activates the whole setting of sensor setup
Disable: Deactivates the whole setting of sensor setup
3.6.4.2 Sensor Mode
This parameter enables or disables sensor mode detection.
Enable: Activates sensor mode
Disable: Deactivates sensor mode

3.6.4.3 Sensor Mapping

This feature is to easily mapping a sensor port to a particular channel without having to
remove any wires.
The default display when all channels are selected is:
sensors for the 16Ch DVRs but the operating principle is still the same.)
Click on a channel you would like to mapping with a sensor. Then select the sensor type is
normally open or closed. It depends on the characteristics of the sensor you intend to use.
DETECTOR SETUP
Channel Number
Alarm Setup
Motion Setup
Sensor Setup
Record Detection Activate
Sensor Mode
Sensor Mapping
Record Time
Alarm Mode
Alarm Time
Trigger Full Screen
Trigger Type
Remember to set up the sensor mode recording for your desired
period on the "Record Schedule" menu in "Record Setup" after
completing "Sensor Setup". Otherwise, the system will still be
recording in the default recording mode.
Compact 4Ch H.264 Network DVR-MU.Ver1.1

[Enable]
[Disable]
[15Sec]
[Mute]
[10Sec]
[OFF]
[Initial Trigger]
. (Note: There are more
43