LDC Racing Saliboats RS FEVA Owner's Manual page 32

 The
rudder stock
 The
rudder downhaul
1) Undo the plastic wing nut on the
2) Slide the rudder
small roller fitted in the stock, and out under the
Small Roller
Rudder Stock
3) Line up the hole in the top of the
4) Push the bolt through the
of the bolt with the recess in the plastic washer, and that the little lugs on the plastic
washer line up with the holes in the stock. It may need a little tap to get it through!
5) Refit the plastic wing nut and tighten. The nut should be tight enough to stop the
rudder slopping about in the stock, but not tight enough to make it hard to rotate the
rudder.
6) Tie the rudder downhaul block
7) Take the rudder downhaul
front end of the tiller.
8) Thread the other end of the
block, and then back through the
9) Tie a figure-of-eight knot
and block
rudder stock
into the stock, making sure that you feed the rope over the
Picture 4.16 Rigging the Rudder
rudder
stock and the rudder. Make sure that you line up the head
onto the rope that you have threaded into the stock.
rope and tie one end onto the bridge of the
rudder downhaul
cleat
in the end.
and remove the bolt.
tiller (see picture 4.16)
with the hole in the
rope through the
on the top of the tiller (see picture 4.18).
Rudder
Rope
rudder stock.
cleat at the
rudder downhaul