Rigging The Jib - LDC Racing Saliboats RS FEVA Owner's Manual

If you are not fitting the jib or the gennaker, move straight on to
To complete this section, you will need:
 1 x Feva
jib
 2 x Feva
shrouds
 1 x
shroud shackle
 1 x
jib halyard block
 1 x
rope pack – containing:
jib
o 1 x
jib halyard
o 1 x
jib sheet
o 1 x
jib halyard block
Before stepping the mast you will need to:
1) Hook the eyelets at the end of the
2) Attach the shroud shackle
the mast (see picture 4.24).
3) Tie a figure-of-eight knot
4) Thread the other end of the
of the jib halyard
knot.
5) Thread the free end of the
between the shrouds.
6) Thread the end of the
of the jib halyard
7) Tie a figure-of-eight knot
block will now hang just below the lower of the two metal rings on the front face of
the mast (see picture 4.25).
Section 4.11 – Completion.

4.9 Rigging the Jib

tie
shrouds
to the lower of the two metal rings on the front face of
in one end of the
jib halyard block
block, pulling the excess through until the
jib halyard block
jib halyard block
block, passing through in the opposite direction to step 4.
in the end of the
onto the shroud
jib halyard block
tie through the metal loop at the top
tie through the
tie back through the metal loop at the top
jib halyard block
shackle.
tie.
block is next to the
shroud shackle, in
tie. The jib halyard