LDC Racing Saliboats RS FEVA Owner's Manual page 18

Mooring
The RS Feva can be
mooring on a buoy, ensure that the
lifting handle (Feva S), or around the
When mooring along side a pontoon, a
forward lifting handle
end of the rear toestraps. Always remember to use some padding between your RS
Feva and the object that you are mooring against!
Trailing and Transporting Your RS Feva
The RS Feva can be trailed behind the majority of cars. When trailing your RS Feva,
you should only use an approved
tying the boat to its trailer because too much or too little tension could result in
damage. We recommend the following procedure for safe trailing:
 Ensure that the boat is located correctly on the trolley, with the
in the bow snubber
 Ensure that the trolley is properly located on the
retaining pin
 Tie the boat down to the
only need to apply sufficient tension to hold the boat in contact with the
supports. Use padding material where any straps touch the deck.
The RS Feva is designed to be transported easily on the roof of most cars. If you are
planning to transport your RS Feva on the roof of your car, we recommend the use
of the RS Feva Folding Launching Trolley, as the combination of the hull and the RS
Feva Standard Launching Trolley may exceed the manufacturer‟s weight limit for the
car.
moored on a buoy
mooring line
tack bar
(Feva S) or round the
trolley
of the trolley.
is fitted.
road base, at the bow, and across the middle. You
or on a pontoon for short periods. When
is securely fastened to the
(Feva XL).
mooring line can be attached to either the
tack bar (Feva XL), and around the
and road base. Care must be taken when
road
forward
bow securely
base, and that the
trolley
aft