Stepping The Mast - LDC Racing Saliboats RS FEVA Owner's Manual

4) Uncoil the main halyard
5) Thread one end through the bullseye at the top of the mast (see picture 4.7).
6) Run both ends of the
place (this prevents them from disappearing back up the mast!).
Now the mast is ready to be put up in the boat, or „stepped‟.
If you are rigging the Jib and Genneker Packs, you need to read Sections 4.9 and
4.10 before stepping the mast
The Mast-Gate Pin
The mast-gate pin
mechanism on the bottom to prevent it from falling out.
To close the mechanism (see picture 4.8):
1) Push the small tang round 90º to the pin
2) Push the tang across until it clicks into place
main halyard
Picture 4.7 Threading the Main Halyard
REMEMBER

4.4 Stepping the Mast

is already fitted to your Feva. The pin has a small locking
to the bottom of the mast and tie in