Equipment Supplied; Installation; Installation Location - Sartorius TopMix2.Touch TM02-X Operating Instructions Manual

Equipment Supplied

°C
8 Operating Instructions TopMix
Equipment Supplied
t
Remove the device from the packaging.
The TopMix comprises the following system components:
– Terminal/control panel (TM02-X), with liquid crystal display and touch screen
for use in Zone 1 potentially explosive areas
– Ex-link converter (YCO12-Z) for installation outside of the potentially explosive
area
– TopMix ex-link cable YCC01-0049M20, for connecting the terminal/control
panel (TM02-X) to the ex-link converter, length: 20 m
– DVI video cable YCC01-0051M3 to connect a standard PC to the ex-link
converter outside the potentially explosive area, length: 3 m
– TopMix PC USB cable (YCC01-0040M3) to connect a standard PC
to the ex-link converter outside the potentially explosive area, length: 3 m
– D-SUB 9-pin cable YCC01-0041M3 to connect a scale,
length: 3 m
– Power supply cable for the ex-link converter
– 3 Grounding cables YCC01-X046M2
– Installation instructions
– Bracket for wall and table installation (YWB06)
Plus any optional accessories not illustrated.
t
After unpacking the equipment, check immediately for any visible external
damage. If you detect any damage, proceed as directed in the "Safety
Inspections" chapter (page 13).

Installation

The TopMix TM02-X terminal/control panel is authorized for use
in Zone 1 potentially explosive areas (see documents).
Make absolutely sure that the device is unplugged from the
power supply before connecting/disconnecting data transfer or
control lines.

Installation Location

Choose a suitable location where the power supply will not be
exposed to drafts, heat radiation, moisture, or vibrations.
t
Remove the protective film from the touch screen.