Power Connection - Sartorius TopMix2.Touch TM02-X Operating Instructions Manual

Installing the TM02-X Terminal/Control Panel
12 Operating Instructions TopMix
Mains Connection
Power is supplied via the power cord provided. In the ex-link converter YCO12-Z
there is a built-in power supply which is designed to operate at supply voltages
between 90 and 264 V and at a frequency of 47-63 Hz. If the stated supply
voltage/frequency is outside of this specification or the type of power supply plug
does not match the rating or standard you use, please contact your dealer.
The ex-link converter YCO12-Z is only suitable for installation outside of the
potentially explosive area.
When operating the TopMix (TM02-X) in potentially explosive areas, follow the
current standards and regulations for the installation of devices in hazardous
areas / locations.
Switching the TopMix Weighing System On and Off
t
The terminal/control panel (TM02-X) can be switched on and off by switching
the PC on and off.
> The ex-link converter YCO12-Z remains in standby mode, even when the PC is
switched off.
A green LED (on the D-SUB plug) illuminates brightly.
If the PC is switched on, the green LED flashes.
The terminal/control panel is switched on by recognizing the video signal.
LEDs: LED – red:
permanent = error
LED – green:
permanent = operational
flashing = operational plus video data
t
Switch the system off when it is not in use.
y
The TM02-X terminal/control panel is now ready for operation and can be
turned on.