Volvo VNL Service Manual page 77

Group 38 Instrumentation, VNL, VNM Service Procedures
3
W3002501
Fig. 85:
Important! Before installing the Left
Circuit Board assembly, check connec-
tor E4 pins and make sure they are all
perfectly straight and parallel to each
other.
4
Place the Left Circuit Board assembly
into the housing while lining up E4 pins
into the Graphic Display connector.
5
Install the Center Module, paying par-
ticular attention to connector E1 on the
Left Circuit Board assembly.
6
Install the left rear cover and secure it
with three machine screws.
7
Install the cluster into the dash (see
"Instrument Cluster, Replacement"
page 62).
8
If installing a gauge blank into the En-
gine Oil Pressure or Turbo Boost
Pressure gauges, use the Pro-Link
9000 with the VOLVO card to enable
the gauge which is being added, or to
disable the gauge which is being re-
moved.
9
Note: If the Left Circuit Board has
been replaced, update the odometer
and hourmeter values to reflect the ve-
hicle's actual mileage and engine
hours. This is done with the Pro-Link.
75