User Instructions - Heatrae Sadia Aquatap Installation & User's Instructions

11.0 USER INSTRUCTIONS

completely automatic.The indicator lights on the dispensing tap will indicate the status
self-calibrating, the AQUATAP will enter this mode after any period the electrical supply
dispense boiling water.
11.2 Hot water drawn from the dispensing tap will at all times
be close to boiling point so due caution must be taken
when using the product, especially if it is likely to be
11.3 Hot water cannot be dispensed unless the safety
should be pressed before the hot water dispensing
button. The dispensing button must be held in the
pressed position to continue dispensing. If it is
again before more hot water can be dispensed.
11.4 In the unlikely event that the full store of hot water is completely drawn off from the
prevent air being drawn through the pump and it possibly air locking, it does not indicate
FIGURE 12 : LED POSITIONS
SAFETY BUTTON
HOT WATER
DISPENSING BUTTON
READY LED
BOILING WATER
LED
17