Installation - Vent Pipe; Installation - Dispensing Tap Mounting - Heatrae Sadia Aquatap Installation & User's Instructions

6.0 INSTALLATION – VENT PIPE
6.1 The VENT connection from the AQUATAP water heating unit is located on the top rear
hose OF the dispensing tap is attached. Refer to section 7.0 INSTALLATION –
DISPENSING TAP MOUNTING below for full details of how to mount and connect the
dispensing tap to the water heating unit.
6.2 The VENT will ensure that any excess steam or pressure is safely vented to
atmosphere in the event of a fault with the unit. IT MUST NOT BE BLOCKED,
OBSTRUCTED, DISCONNECTED OR REMOVED.
7.0 INSTALLATION – DISPENSING TAP MOUNTING
7.1 The dispensing tap supplied is suitable for mounting onto a worktop or counter
surface. It should be positioned such that it discharges into a sink or drip tray (FIG. 6,
page 11 for tap dimensions). A purpose designed drip tray is available as an
accessory (order Product Code 95970138). If this is used, then the instructions
supplied with the drip tray accessory should be followed.
7.2 Cut a 35mm diameter hole in the position selected through the worktop or counter
surface or use the template provided if using the drip tray. NOTE: Do not mount the
dispenser directly onto a stainless steel sink.
hoses to the dispenser tap with the clips provided.
7.4 Ensure the sealing washer provided is correctly located on the base of the tap. A light
application of clear silicon sealant on the base of the tap and the sealing washer will
the top and position the tap base onto the worktop.
If necessary adjust the position of the dispenser tap and then tighten the securing nut.
7.8 Make sure all pipe work is bonded and the earthing clamps conform to BS 951 and
REMOVE".
10