Heatrae Sadia Aquatap Installation & User's Instructions page 17

after a short delay but may result in the calibration temperature being too low. Should this
occur the electrical supply should be switched off for several seconds. When switched on
ANY WATER OFF DURING THE SELF COMMISSIONING MODE.
residues and pasteurise the surfaces in contact with the water.
by the hot water button. The hot water dispensing button must remain
If released it will be necessary to press
water can be dispensed.
power is switched off and the AQUATAP casing
removed to check for any internal leaks.
ALWAYS DISCONNECT THE ELECTRICAL
SUPPLY BEFORE REMOVING THE COVER.
If there are no leaks evident, replace and secure
the front casing. Switch on the electrical supply.
AQUATAP unit will be ready for use.
10.11 Following commissioning, the following should be explained to the user:
malfunction of the unit or dispenser tap any maintenance or servicing must only be
carried out by a competent installer.
the correct use of the system.
10.12 The commisioning record should be completed (see Section 15.0, page 28).
10.13 These instructions should be left with the user for future reference.
16
FIGURE 11 : OPERATING BUTTONS
SAFETY BUTTON
HOT WATER
DISPENSING BUTTON
DO NOT DRAW