User Instructions - Heatrae Sadia Aquatap Installation & User's Instructions

10.12 The commisioning record should be completed (see Section 15.0, page 31).
10.13 These instructions should be left with the user for future reference.

11.0 USER INSTRUCTIONS

11.1 Once installed and commissioned, the filling and heating cycles of the AQUATAP are
completely automatic.The indicator lights on the dispensing tap will indicate the status
of the system. If the "READY" light is flashing this indicates that the unit is
self-calibrating. The AQUATAP will enter this mode after any period when the electrical
supply has been switched off. DO NOT draw off water whilst the "READY" light is
flashing. When the "READY" light stops flashing and remains illuminated, the unit will be
ready to dispense boiling water.
11.2 Hot water drawn from the dispensing tap will at all times
be close to boiling point so due caution must be taken
when using the product, especially if it is likely to be
used by children, aged or infirm persons.
11.3 Hot water cannot be dispensed unless the safety
lock is turned off. The button marked "SAFETY"
should be depressed before the hot water dispensing
button.The dispensing button must be held in the
pressed position to continue dispensing. If it is
released, the "SAFETY" button must be pressed
again before more hot water can be dispensed.
If either the HOT button or CHILLED/AMBIENT button is pressed, the other button will
not activate.
11.4 Ambient/chilled water is dispensed by depressing the CHILLED/AMBIENT water
dispensing button. The safety button does not need to be depressed for dispensing
chilled/ambient drinking water.
11.5 In the unlikely event that the full store of hot water is completely drawn off from the
AQUATAP, the pump will stop and flow from the dispenser will be interrupted. This is to
prevent air being drawn through the pump and causing an air lock. It does not indicate
a fault with the heater. Should this happen, the "READY" indicator will flash. After a few
minutes, the unit will have re-filled to a level where hot water can again be drawn off.
This will be indicated by the "READY" indicator remaining lit.
11.6 If the AQUATAP is not used for a few days, the stored water may become "stale". In
these instances, it is advisable to draw off and discard the entire contents to flush
through the "stale" water. This will ensure that freshly boiled water is available for
dispensing.
11.7 Occasionally some scale residue may be drawn from the unit with the dispensed water
which may cause the water to appear "milky" for a short while. This is completely
harmless and will quickly clear if left to stand. Alternatively a few cups of water can be
dispensed and discarded until the water flows clearly.
FIGURE 14 : LED POSITIONS
SAFETY BUTTON
HOT WATER
DISPENSING BUTTON
CHILLED/AMBIENT
WATER DISPENSING
BUTTON
READY LED
BOILING WATER
LED
19