Installation - Dispensing Tap Connection - Heatrae Sadia Aquatap Installation & User's Instructions

8.0 INSTALLATION – DISPENSING TAP CONNECTION
8.1 The hot supply hose should be connected to the OUTLET hose spigot of the AQUATAP
water heating unit. The hose should rise continuously from the heater to the tap without
kinks or twists. If necessary it can be cut to a shorter length, but it should never be
lengthened. The hose should be secured in place on the spigot using the clips provided.
Warning, only use the hose supplied with the unit or a temperature rated WRAS
approved hose. Spare hose and clips can be ordered, part number 95 607 364.
8.2 The VENT hose should be connected to the VENT hose spigot of the AQUATAP water
heating unit. The hose should rise continuously from the heater to the tap without kinks
or twists. If necessary it can be cut to a shorter length, but it should never be lengthened.
The hose should be secured in place on the spigot using the clips provided.
FIGURE 7 : TAP MOUNTING (BOIL ONLY)
(NOTE: DRIP TRAY/SINK NOT SHOWN FOR CLARITY)
12
CLAMP
HOT TAP
OUTLET
HOSE
TAP
VENT
HOSE
CLAMP
DISPENSER CABLE
FUSED SPUR
1.5mm 3 CORE HOFR
SHEATHED CABLE
FLEXIBLE
HOSE
MAINS
ISOLATING
WATER
VALVE
SUPPLY