Table of Contents
Advertisement
Locations and Functions of Parts
Inside panel
a Slot for tuner unit
Mount a WRR-855A UHF synthesized tuner unit of the
wireless microphone system.
For details on mounting, see "Mounting the WRR-855A"
on page 17.
b RF OUT connector
Mount the supplied transmission antenna.
Note
Do not use any antenna other than the supplied one.
c DISPLAY button and display
The display shows various information, such as the
operation statuses, setting menus, and alarm messages.
You can turn the display ON/OFF with the DISPLAY
button.
When you turn on the power to this unit, CPU initialization
begins, and an initialization message appears.
When the initialization ends, the display changes to the
status indications.
DISPLAY
CANCEL
MENU
DC LINE
TX ON/CALL
Status indications
Intercom level
Reception level
of the WLL-RX55
Reception level of
the slot-in unit
For an Info-Lithium battery, the remaining (%) is displayed.
For a non-Info-Lithium battery, the voltage is displayed.
If an error is generated, an alarm message will be displayed
at the center of the display.
When using an Info-Lithium battery, an alarm will be
displayed for the value set for "Low Batt" (percentage) of
the Setup menu. For a non-Info-Lithium battery, it will be
displayed for the value set for "Low Batt" (voltage).
a Slot for tuner unit
b RF OUT connector
c DISPLAY button and display
d MENU dial
e CANCEL button
f TX ON/CALL button
g DC LINE switch
Transmission
Time interleave
frequency
mode
Output mode
2406MHz
High
Incom 50
RX sssssssss
CA sssssssss
Standard
13.5V
Transmission mode
Locations and Functions of Parts
Fast
11
Advertisement
Table of Contents
