Parts Identification; Optical Transmitter Zra-T1 - Sony ZRA-T1 Operating Instructions Manual

Parts Identification

Optical Transmitter ZRA-T1

Front
 POWER indicator
Indicates the power status of the product.
Off: Power is turned off.
Blinking red: Power error occurred.
Lit green: Power is turned on (normal
operating status).
 INPUT indicator
Indicates the status of RJ45 input connectors
1 to 3.
Off: RJ45 input connectors are not connected
or not linked with the Display Controller.
Lit green: RJ45 input connectors work
properly.
Blinking red: An error occurred on RJ45 input
connectors*.
* If the indicator is blinking every
0.25 seconds, turn off the power and on
again. If it is still not improved, contact your
local Sony representative.
 OUTPUT indicator
Indicates the status of the SFP+ output
connector.
Off: The SFP+ output connector is not
connected or not linked with ZRA-R1.
Lit green: The SFP+ output connector works
properly.
Blinking red: An error occurred on the SFP+
output connector.
Note
The INPUT indicator and OUTPUT indicator blink
in red for about 5 seconds shortly after turning
the power on or connecting cables. If blinking in
red continues for over 30 seconds, turn off the
power and on again or check the cable
connection. If it still does not improve, contact
your local Sony representative.
Rear
 DC power input connector (USB Type-C)
Use a USB Type-C - Type-C cable (not
supplied) to connect this connector to the
USB Type-C output on the USB AC adapter
(not supplied).
For the USB AC adapter, use a product with a
USB Type-C with an output voltage of 5 V or
higher and an output current 2 A or higher.
For the USB Type-C - Type-C cable, use a
product with a current 2 A or higher.
 INPUT connectors 1 to 3 (RJ45)
Use a Category 7 cable (not supplied) to
connect this connector to the OUTPUT
connector on the Display Controller.
The connectors 1 to 3 correspond to the
OUTPUT connectors 1 to 3 of ZRA-R1
respectively.
Up to 3 cables can be connected to these
connectors. Connect to connector 1 when you
connect 1 cable, connector 1 and 2 when you
connect 2 cables, and all connectors when
you connect 3 cables.

OUTPUT connector (SFP+)
Use an SFP+ transceiver module (not
supplied) and optical fiber cable (not
supplied) to connect this connector to the
INPUT connector on ZRA-R1.
This product is authenticated with safety
standards for use in combination with the
SFP+ transceiver module.
Contact your local Sony representative for
other SFP+ transceiver modules.
• OTM-10GSR1 (Sony Corporation)
5