Thermostat - Lopi Spirit Bay Owner's Manual

O
PTIONAL
P 28
AGE
Remote Control (continued)
5. Replace the ashlip control housing. Make sure none of the wiring is pinched. Determine the
location of the remote control receiver. Find a location that is within reach of 10' of wire. Route
the remote control receiver wire to the location and connect it to the remote control receiver by
attaching the quick connects (the orientation of the wires does not matter).
6. Place a nine volt battery inside the remote control receiver and remote control (see the
illustration below).
Remove this
screw with a
phillips head
screwdriver.
7. Mount the remote control receiver to the wall using two screws (not included). The screws pass
through the cover plate and hold the remote control receiver in place.
The distance between the
mounting holes is 3 1/4".
8. Test the remote control's operation prior to leaving the installation. Start the pilot, let it run five
minutes, then turn the on/off switch on the heater to "ON". Switch the remote control receiver to
"REMOTE". Press the remote control for one second to turn the heater on and off. If it does not,
check all of the electrical connections and re-test. When the remote control receiver is turned to
"ON" the heater will stay on, when on "OFF" the heater will stay off, regardless of the remote
control.

Thermostat

(Part # 99300650)
The thermostat allows the main burner to turn on and off automatically for consistent room temperature.
Follow the directions below to install.
1. Follow step 1 and 2 under "Remote Control" to remove the ashlip control housing and jumper
wire (see page 27).
2. Follow step 3 under "Remote Control" to feed the thermostat wire through the ashlip control
housing (see page 27).
E (C
QUIPMENT
Mount a 9 volt battery in
both the remote control and
remote control receiver.
Remote Control Receiver
Cover Plate
)
ONTINUED
This clip holds the
battery in place.
Attach the remote
control receiver
wire to these two
quick connects.
The screws insert here (screws not included)
The hole must
be 1 3/4" wide.
The hole must
be 2 1/2" tall.
Remote
Control
Receiver