Thermostat - Lopi Heritage Bay Insert Owner's Manual

Thermostat

(Part # 99300650)
! Do not connect 110-120 VAC to the gas control valve or wiring of this unit.
1 Route the thermostat wire under the burner pan and connect to the on/off switch (see the illustration
below).
Open the
a
access door.
2 Pull through all the slack in the thermostat wire. Determine a location for the thermostat that is
within range of the 50' length of thermostat wire. It should be centralized in the room and away
from the heater. The wire may be routed externally on the wall or behind the wall (preferred).
3 Cut the thermostat wire so there is approximately 6" of slack (NOTE: Do not splice thermostat wires
togetherÐthis leads to too much electrical resistance). Follow the instructions below to install the
thermostat.
d
Attach the thermostat to
the wall through these
two holes.
e
Re-attach the cover
removed in step ÒaÓ.
O
PTIONAL
Route the wire under the burner pan
b
forward, underneath this clip (this
prevents it from touching the bottom
of the burner pan.
Back of
on/off
switch
50 60 70 80 90
50 60 70 80 90
Robertshaw
E (C
QUIPMENT
Remove the green
c
jumper wire.
d
Attach the quick connects
from the wire to the two
posts on the on/off switch.
Pull the cover off the thermostat
Run the thermostat wires
through the wall (cut off excess
wire, leaving 6Ó of slack).
c
Expose 1/2Ó of wire and
attach to these two posts.
Standard
Screwdriver
)
ONTINUED
P
AGE
Back of
on/off
switch
a
b
23