Light Emitting Diodes (Led) - Studer XP-COMPACT-XPC 1400-12 User's And Installer's Manual

STUDER Innotec
4.3

Light Emitting Diodes (LED)

LED Marking
1 AC IN
2 CHARGER
SOLAR
3
CHARGE
4 Program
Contact
5
active
Contact
6
manual
7 TRANSFER
8 AC OUT
9 INVERTER
10 Over Temp.
11 Overload
Batt.
12
Low/High
13 OFF
14 EQUALIZE
15–18
LED lit
Voltage
corresponding to
self-adjusted
values is at the AC
IN input.
Battery charger is
working
Connected solar
modules are
delivering energy
Program mode for
Aux. Contact
Auxiliary Contact is
activated
Aux. Cont.
manually activated
Transfer system is
active. In- coming
voltage is being
sent directly to AC
OUT outlet
There is a voltage
at the AC OUT
outlet
Inverter is working
For the time being
the XP-COMPACT
is out of service
because of
overheating.
The XP-COMPACT
is out of service
because of
overload or short-
circuit
Battery voltage is
too low
XP-COMPACT is
turned off. Turning
it back on is only
possible manually.
Battery equalizing
is set
State of charge of
the battery
XP-COMPACT V5.7
LED blinks
A voltage outside the self-adjusted
values is at the AC IN input, or the XP-
COMPACT is in synchronization
phases
The battery charger is locked OFF
(see chap. 4.7) or provisory out of
order. In that last case it will restart
within 10 seconds
Transfer (bypass) is disabled (see
chap. 4.8)
The Inverter is in Standby-Mode
Forced Inverter Mode (see chap. 4.6)
Battery voltage is or was to high
XP-COMPACT is for the time being
turned off. Turning it back on will
follow automatically !
LED 15 – Absorption time is running
XP-COMPACT
15/79