Table of Contents
Advertisement
ACP-2212P Chapter 2 Installation
2.1 ACP-2212P Hard Disk Installation
1.
First secure the hard disk handles included in the packaging to the hard
disks with the screws provided as shown in the picture below:
I.
III.
2.
Unscrew and remove the ACP-2212P front panel as shown in the picture
below:
I.
3.
Now insert the SATA hard disks fitted with the hard disk handles into the
ACP-2212P along the guide rails with the front side facing upwards. Push
the hard disks until the contacts are securely attached as shown in the
picture below:
I.
**Attention: Users with only one HDD must connect it to the HDD1 port. The
device can then connected to the host computer via the USB cable and used
directly.
8
II.
II.
II.
HDD 1
Note:
To fit along guide rack
HDD 2
Advertisement
Table of Contents
