Table of Contents
Advertisement
ACP-2212P Chapter 2 Overview
1.5 Quick Setup
1.
Prepare two identical 2.5" SATA hard disks.
2.
Fit both hard disks with the HDD Rack Handle and screw securely into
place.
3.
Open and remove the ACP-2212P front panel.
4.
Take the hard disks by the Rack Handle and then insert them into theACP
-2212P system with the SATA interface facing inwards. Check that the
SATA hard disks' data and power connectors are securely affixed to the
data and power connectors in the ACP-2212P system.
5.
Replace the ACP-2212P front panel and screw securely in place.
6.
Connect the power supply to the ACP-2212P and start device.
7.
Connect the USB 2.0 B-type cable to the ACP-2212P.
8.
Connect USB 2.0 A-type connector at the other end of the cable to the
computer's USB interface.
9.
Once the computer boots up the system will detect a hard disk named
Mirror USB Device. Partition and format the Mirror USB device if necessary.
**Attention: If only one single HDD is used and the device is not connected to
an external power supply, the HDD must be installed in the HDD 1 position. It
will not be detected by the system if installed in the HDD 2 position.
1.6 Hard Disk Compatibility
The ACP-2212P is designed for use with 2,5" SATA hard disks. The latest list
of compatible hard disks is available online from: http://www.acard.com
If your hard disk is not included in the ACARD compatibility list, please contact
us or your distributor.
6
Advertisement
Table of Contents
