When Atapi Device Is Defective; Cd Player Mode - Yamaha CDR-HD1500 Service Manual

QQ
3 7 63 1515 0

When ATAPI device is defective

Possible symptom varies depending on the
defective point.
• "Drive Check" is displayed.
• Only the scale of the level meter is displayed.
• Switching the drive switch causes hang-up to occur.
• Abnormal mechanical noise is heard from the unit.
Is abnormal
mechanical noise
heard from
HDD?
NO
Check the
IDE cable.
OK
Check the
CD-RW drive
operation by using the
*CD Player
mode.
OK
TE HDD defective
L 13942296513
* For the CD Player mode, refer to the
description of the CD Player mode.

CD player mode

Using the CD player mode, the CD-R/RW drive can be
operated independently.
1) Turn off the power.
2) Disconnect the IDE cable connected to HDD.
3) Turn on the power.
After the same display as at the normal start-up, "Wait"
flashes and after about 30 seconds, the CD player
mode is activated.
In order to make the start-up time shorter, turn on the
power while pressing the "
simultaneously and then keep pressing the "
and "MENU" key.
4) Press the " " key to open the tray and load a CD on the
tray.
5) Press the " " key to close the tray.
www
6) Press the "
7) Check that the CD sound is heard properly from the
LINE OUT terminal.
.
http://www.xiaoyu163.com
YES
HDD defective
IDE cable
NG
defective
CD-R/RW drive
NG
defective
" key and "MENU" key
" key.
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
NO
OK
OK
Q Q
3 6 7 1 3 1 5
" key
co
.
CDR-HD1500
9 4 2 8
YES
NG
NG
0 5 8 2 9 9 4 2 8
m
9 9
9 9
17