Connecting External Equipment; Connecting A Video Recorder - Beko P7 Service Manual

Connecting external equipment

AV Inputs:
Press the ( ) button on your remote control. You
will enter the Source menu from where you can
elect the screen input mode. Here select the input
you desire.
TV:
To move to TV mode while in AV modes,
move on to the selection and press the (
button.
Scart1:
To be able to view the broadcasting
images form the device connected to Scart1,
move on to the selection and press the (
button. (If the connected device has an RGB
output, you will be able to watch it over Scart.)
Scart2:
To be able to view the broadcasting
images form the device connected to Scart2,
move on to the selection and press the (
button. (If the connected device has an RGB
output, you will be able to watch it over Scart.)
SVHS:
To be able to view the images form the
device connected to the S-Video input, move on
to the selection and press the (
AV:
To be able to view the images form the
device connected to the RCA (Chinch) input,
move on to the selection and press the ( ) button.
PC:
To be able to view monitor images in PC
mode, move on to the selection and press the
( ) button.
DVI:
To be able to view images in DVI mode,
move on to the selection and press the ( ) button.

Connecting a video recorder

Via SCART
Make sure the TV and video recorder are both
switched off.
Plug one end of the SCART lead (not supplied)
)
into the back of the video recorder and the other
end into one of the SCART sockets on the back
of the TV.
Switch on the video recorder and the TV.
)
)
Please note: You can connect RGB external
equipment via Scart. It is necessary to you use
a full Scart cable for this purpose.
) button.
Select the video output of the external device
by using its menu, and set to RGB.
Via RCA lead (optional)
Make sure the TV and video recorder are both
switched off.
Plug one end of the RCA lead into the video and
audio out sockets on the back of the video
recorder and plug the other end into the video
and audio in sockets of the TV.
If the sound is mono, use the Audio Input L. and
in the SOUND menu select the MONO feature.
Press the ( ) button on the remote
control to select SCART1 or SCART2 to
correspond with the SCART socket you
are using on the back of the TV.