Advertisement
(select the
If the input audio is higher than 48KHZ, the original audio will be
down sampling
downsampled to 48KHZ, or lower. If the audio device supports
frequency of
audio input higher than 48KHZ, then this option is not
digital audio
recommended.
signal PCM
If the input audio is higher than 96KHZ, the original audio will be
code)
downsampled to 96KHZ, or lower. If the audio device supports
audio input higher than 96KHZ, then this option is not
recommended.
If the input audio is higher than 192KHZ, the original audio will
be downsampled to 192KHZ, or lower. If the audio device
supports audio input higher than 192KHZ, then this option is not
recommended.
Dynamic range is the difference between the minimum audio
strength high than device noise and the maximum audio
strength before distortion. Enable dynamic compression for
viewing at night.
(Set dynamic
compression to
ON/OFF)
2X (configuration when two channels are connected)
(Select
First step: select the audio channel mode
according to
L/R: select this option if your power amplifier is compatible with
connected
Dolby Pro Logic;
speaker and
Stereo: select this option if the player is connected to a stereo
power
power amplifier.
amplifier)
Second step: select the quantity of bass
None: select this option if you have no subwoofer;
Single: select this option if you do have a subwoofer
Third step: select the speaker to be set
If the bass quantity is "none", you can select to set left/right
speaker.
If the bass quantity is "single", in addition to the left/right
speakers you can also set the subwoofer
Fourth step: set the selected speaker as follows:
Size: set according to the speaker size, select large if the cross
section area is larger than, or equal to 16cm
small.
Tuning: adjust the audio output strength of the speaker in the
range of -10~10dB.
Delay: set the distance between the speaker and the listener by
5cm in the range of 0~1000cm.
Size: set according to speaker size. Select large if the cross
section area is larger than, or equal to 16cm
small.
Tuning: adjust the audio output strength of the speaker in the
range of -10~10dB.
Delay: set the distance between the speaker and the listener by
5cm in the range of 0-1000cm.
(enable dynamic output compression)
(disable dynamic output compression)
2
, otherwise select
2
. Otherwise select
21
Advertisement
