Polaroid Miniportrait 204 Repair Manual page 39

Repair Manual
4. Press the aiming button and move the camera away from the target until the
converging light beams are aligned on the target. In the illustration below,
both beams are properly aligned on the horizontal axis.
However, if one light is higher than the other, as shown below, it must be
adjusted downward.
Lower the Aiming Light as follows: (Refer to Figure 3-4)
a) Access "Aim Lamp" in the diagnostic menu as described in Section 2 of
this manual. The Aiming Light will blink for one (1) minute so that it can be
checked and adjusted if necessary.
b) Insert a 1/32 inch allen wrench into the Aiming Light adjustment opening
in the Rear Housing (Figure 3-4). Note: There are two adjustment
openings, one for the left Aiming Light and one for the right Aiming Light.
c) Turn the adjustment screw clockwise until the beam is lowered into
vertical alignment with the lower beam as shown in number 4A above. At
40 inches, the beams will be superimposed for proper framing on the
subject's chin.
Model 204/404 MiniPortrait Camera
4A
4B
39