Polaroid Miniportrait 204 Repair Manual page 31

Repair Manual
Continued
No image in LCD display
screen.
No LOAD FILM message
(either no message or
wrong message) when
camera is out of film.
LOAD FILM message
stays on at all times,
even when camera has
film.
No PULL FILM message
in LCD display after
loading film.
PULL FILM message
stays on at all times;
even after film is pulled.
System may have shut
down after preset time
while in auto mode. If
yes, take corrective
action. If not, see below.
Check the battery; or AC
adapter (whichever is
being used). If battery is
dead or AC adapter is
defective, take corrective
action. If not, see below.
Check to see if 5 volts is
coming off the power
board. If not, take
corrective action. If yes,
see below.
Logic board is defective.
Take corrective action. If
still no image, see below.
LCD display has failed.
Defective load film
sensor unit; not sensing
film in film compartment,
broken wire(s), or dirty
sensor unit.
Load Film/Pull Film
harness not plugged into
J3 on the logic board.
Load Film/Pull Film
harness not plugged into
J3 on the logic board.
Pull film switch sticking in
closed position. If yes,
take corrective action. If
not, see below.
31
Model 204/404 MiniPortrait Camera
Press program mode
button to re-activate
system.
Replace battery, or AC
adapter.
Replace power board.
Replace logic board.
Replace LCD display.
Replace load film sensor
unit; or wire(s) as
necessary. Or, clean
sensor unit if needed.
Plug harness into J3 on
the logic board.
Plug harness into J3 on
the logic board.
Clean pull film switch.