Step 5. Viewing And Changing The Time Location; Changing The Format Of The Counter Display; Changing The Current Time Location; Using Locate Points To Change The Time Location - Korg D4 Owner's Manual

D4 digital recorder owner's manual
Hide thumbs Also See for D4:
Table of Contents

Advertisement

Step 5. Viewing and changing the
time location
This section explains how to use the counter display, how
to use locate points, and how to select a different time
location within a song.

1. Changing the format of the counter display

The counter display format shown in Play mode can be
switched according to your needs. You can switch
between the following two time display formats.
"minutes": "seconds" .
"1/1000 second"
"measures" . "beats" . "1/96 beat"
Set the [MODE] knob to "Locate" (Locate mode), and turn
the [VALUE] dial to change the display format. (→p.62)

2. Changing the current time location

1 Set the counter display blinking.
In the Locate or Play mode, when the counter is dis-
played, pressing the CURSOR [
counter display begin to blink.

3. Using locate points to change the time location

] key will make the
2 Use the [VALUE] dial to change the time location.
Now turn the [VALUE] dial to change the location. To
move the cursor between the various units of change,
use the CURSOR [
]/[
right will switch to a new screen that will allow you to
move in smaller units.
If "LocMoni" (→p.57) is turned "On," you will be able to lis-
ten to the sound as you change the time location. This can be
useful for setting locate points with greater accuracy.
3 Return to the normal Play mode.
When you press the [EXIT] key, you will return to the
initial counter mode. To move from the middle of the
song to the beginning, press the [REW] key.
You can register a specific time location as a "locate point"
and then move instantly to the registered time location
whenever you want. The times you register are also used
for auto punch-in/out recording and for track editing.
You can use locate points to move even while the song is
playing.

Registering the IN and OUT locate points

1 Move to the time location that you want to register.
2 Press the [STORE] key.
The key will light.
3 Press the key ([IN (LOC1)] or [OUT (LOC2)]) that
you want to register to this time location.
The time will be registered to that key. The registered
time will be displayed briefly, and the [STORE] key
will go dark.
Operation
] keys. Moving toward the
35

Advertisement

Table of Contents
loading

Table of Contents