Sony Ericsson Aino - U10 Troubleshooting Manual page 5

Customized Power Supply Channel 2 Cable (DCIO/SEPI)
Customize the cable according to the instructions below:
(Step 1, Step 2, Step 3 and Step 4)
Step 1:
Take the CST-75 battery charger and cut off the charger according to Picture 7.
Picture 7
Note! The Cable length must be exactly 1.3m.
Step 2:
Connect the CST-75 charger Red or White wire to the Plus Output and the Black wire to the Minus
(GND) Output at backside of the Power Supply Channel 2 (DCIO/SEPI) according to Picture 8.
Picture 8
Step 3:
Cut off insulating material from the inside of the charger plug according to Picture 9.
Picture 9
ABOUT Equipment List
Step 4:
Connect DCIO Cable and SEPI Interface Cable – A1 according to Picture 10.
Picture 10
Picture 11
Note! This setup is wrong.
SEMC Troubleshooting Manual
Aino - U10
1235-5821 rev. 1 5 (57)