Editing A Song; Setting Cycle Play; Erasing A Track - Korg C-520 User Manual

Editing a song

After having been recorded, a user-created song can be edited, and then saved again in the User Song album. Please note that songs con-
tained in albums other than UserSong cannot be edited. The only Edit function that can be accessed with these songs is the Cycle Play.

Setting Cycle Play

Cycle Play allows you to repeat a passage during play, to prac-
tice with it over and over.
Note: If you enter editing later, you might see a different edit
page instead of the first one. Use the SCROLL
reach it.
1.
While in Song Play mode, press the EDIT button. The first
page of the Song Edit mode will appear. This is the Cycle

Erasing a track

You can erase a single or all song tracks, to start recording
them again, or just remove them from the song (for example,
the voice track you want to sing live).
1.
After having pressed the EDIT button, use the SCROLL
button to go to the Erase Track edit page:
Erase Track
All
2.
Use the +/YES and -/NO buttons to select one of the fol-
lowing tracks:
Option Meaning
All All tracks – this results in an empty song
Tr01 (P2), Tr02 (P1) Respectively, Recorder Parts 2 (Track 1)
and 1 (Track 2)
Tr 10 (Dr) Drum part (Track 10)
Tr03 ~ 09, 11 ~ 16 Tracks 3 ~ 9, 11 ~ 16 (Extra tracks)
button to
2
Exec?
Editing a song > Setting Cycle Play
Play mode, whose use has been seen above (see "Cycle
Play" on page 29):
Cycle Play
On S:001 E:001
Start Measure
2.
Press the EXIT button to return to the Main page and start
practicing.
3.
Press the SCROLL button to move the cursor to the
Exec command.
4.
Press +/YES to start erasing. The "Are you sure?" message
appears. Press +/YES to confirm, -/NO to cancel and keep
the track.
5.
Press the EXIT button to return to the Main page and save
the changes (see "Saving the song after editing" on page 39),
or the SCROLL button to go to the next edit page (see be-
low).
1
End Measure
37