Table of Contents
Advertisement
7.1 CONTROL switch
This switch controls an effect. For each program, you can assign what effect
parameter this switch will control. For details, refer to "Control switch settings"
on p.43.
7.2 EXP (Expression) pedal
This controls volume, wah, or another effect parameter. For each program, you
can assign just what this pedal will control (p.40). When using ESS, manual
control of the sequence speed or step is assigned to this pedal. By advancing
this pedal forward to press the switch that's mounted under it, you can turn the
expression pedal or the effect being controlled by ESS on/off. (This switching
operation is not available if the EXP pedal is controlling the volume.)
8
ESS/P
EDAL INDICATOR
8.1 ESS/Pedal indicator/Tuner display
When you're using ESS, this indicates the total number of steps (LED: green)
and the current step (LED: red). When you're using the expression pedal, this
indicates the current position of the pedal (LED: red). When the Tuner is oper-
ating, this functions as a tuning meter (LED: red or green).
NOTE: What happens when you change programs will depend on the target that's
assigned to the expression pedal, as follows.
If the expression pedal is assigned to VOLUME, DELAY INPUT, or REVERB
INPUT, or if it is assigned to the same target as in the previous program, the pedal
position will be valid immediately after the program change, and the pedal indicator
will light.
In other cases, the value specified within the program will be valid immediately
after the program change, and the pedal indicator will be dark until you move the
pedal.
/T
UNER DISPLAY
8.1
9
Advertisement
Table of Contents
