Display/Cursor Section - Korg ToneWorks AX3000G Owner's Manual

3.1 AMP/LINE button
This button lets you make appropriate settings for the device to which your
AX3000G is connected. The
the destination device you've selected (p.12).
3.2 GLOBAL button
You can press the GLOBAL button and use the √ √ √ √ /® ® ® ® buttons to move through
the menus in the following order. After you've selected a menu item, use value
knob 1 or the ▲/▼ buttons to edit the value.
MIDI CH: MIDI channel setting
PCHG OUT: Program change message output setting
CCHG I/O: Control change message input/output setting
SYEX OUT: System exclusive message output setting
DUMP CUR: Send the current program data from the MIDI OUT jack
DUMP ALL: Send all of the AX3000G's data from the MIDI OUT jack (p.51)
DOUT LVL Set the S/P DIF output level in a range of five levels;
–12, –6, 0, +6, +12 [dB]
3.3 WRITE button
Use this button when you want to save the settings you've created (p.19).
3.4 EXIT/TUNE button
Use this button to cancel a "program save" operation or a setting you ' ve made.
If the name display shows a program name, pressing this button will start up the
built-in Tuner. By pressing and holding down this button, you can enable or dis-
able the Key Lock function, which disables operation of the buttons, selectors,
and knobs (p.16, 21).
4 D /C
ISPLAY URSOR SECTION
4.5
4.6
4.7
4.8
This area displays the program name, and the name and value of the parame-
ters you're editing in the amp or effect section.
4.1 ▲/▼ buttons
Use these to edit the value of parameters.
icon in the display will change depending on
4.3 4.4
6
4.2
4.1
(p.49)
(p.49)
(p.49)
(p.50)
(p.51)