Parameter Change (Global "Syex Out") - Korg ToneWorks AX3000G Owner's Manual

1. Press the GLOBAL button.
2. Press the √ √ √ √ /® ® ® ® buttons to make the name display read "CCHG I/O."
3. Specify whether all control change messages will be transmitted or received.
Use value knob 1 or the ▲/▼ buttons to make your choice.
"On" allows transmitting and receiving. "OFF" disables transmitting and receiv-
ing.
NOTE: If this setting is "OFF," no control change messages will be transmitted or
received even if you specify individual control change numbers in step 4.
4. Simultaneously press both √ √ √ √ /® ® ® ® buttons to access the screen where you can
set control numbers individually. Use the √ √ √ √ /® ® ® ® buttons to select each control-
ler.
The controllers will be selected in the following order.
" EXP PDL" Expression pedal control
" CTL PDL" Control switch (pedal) on/off
" PRE FX" PRE FX effect on/off
"D/AMP FX" DRIVE/AMP effect on/off
" MOD FX" MODULATION effect on/off
"DELAY FX" DELAY effect on/off
"REVRB FX" REVERB effect on/off
5. For each controller, specify whether the AX3000G will transmit and receive con-
trol change messages. If you want the AX3000G to transmit and receive mes-
sages for a controller, specify the control change number. Select a controller,
and use value knob 1 or the ▲ / ▼ buttons to make the desired setting.
"OFF": Control change messages will not be transmitted or received.
"CC00"–"CC95": When you operate a controller, messages of the specified
control change number 00–95 will be transmitted. Similarly, the AX3000G will
be controlled when it receives messages of the same control change number
from an external MIDI device.
6. To return to the screen where you specify transmit or receive for all control
change messages, press both √ √ √ √ /® ® ® ® buttons simultaneously.
P C
ARAMETER
When you operate the AX3000G's knobs or buttons to edit the value of a parame-
ter, system exclusive such as parameter changes are transmitted.
If you want the AX3000G's parameters to be transmitted to an external device,
turn the "SYEX OUT" setting "On." Normally, you will turn "SYEX OUT" on when
using the Sound Editor.
This setting specifies whether the AX3000G will transmit parameter changes.
1. Press the GLOBAL button.
2. Press the √ √ √ √ /® ® ® ® buttons to make the name display read "SYEX OUT."
HANGE (GLOBAL "SYEX OUT")
50