Selecting Your Source - Care Messenger DVB-OTT-STB Installation & Setup

8: Selecting your source

Choose between a wired or WiFi connection
#
If you are using a wired connection to your internet router, this
must be plugged into the Care Messenger Ethernet port. If
you are using a wireless/Wi-Fi connection there is no need to
connect a network cable. A wired connection can be more
reliable if you are able to use one.
Power up your Care Messenger device
Connect the small round metal connector on
the cable from the power supply provided into
the port on the Care Messenger device
marked 'DC 12V/1.5A', then plug the power
supply into the wall socket and switch on.
Select the Care Messenger source on your TV
You will have to select the correct input / source on your TV
to be able to see the setup screens. To do this you need to
use your existing TV remote. To switch inputs
you will need to use whichever button cycles
through the various inputs. This may be
labelled AV, INPUT, SOURCE, and look like this:
The correct input will usually be HDMI 1 or HDMI
2. You will know you have the correct input once you see the
image shown on Page 12 of this manual on your screen. When
you can, if possible make this the default input for your TV
viewing. This is the input Care Messenger uses.
NOTE: All other steps in this manual refer to the remote we
have supplied, not your existing TV remote.
11
Support: call 0191 206 4004 or visit www.caremessenger.co.uk