Installing The Spool Pin; Installing The Knee Lifter Assembly - Consew 206RBL Instruction Manual

4-4. Installing the spool pin
(
4. INSTAllATION
Insert the spool pin
0
into the installation hole. and
screw it in tightly.
4-5. Installing the knee lifter assembly
- 4 -
1. Assemble the knee lifter assembly
0
as shown in
the illustration.
NOTE: Make sure that the knee lifter stopper.
is facing in the correct direction.
2. Install the knee lifter assembly
0
on the back of
the table with 4 screws
e.
(Refer to the work table
processing diagram on page 2.)
3. Adjust the knee lifter.
1) Lower the presser foot
e
by using the presser
bar lifter
e.
2) Loosen bolts ••• and
O.
3) Adjust the position of the thrusting bar com-
plete ., so that the clearance between its
curved section and the very bottom of the roller
• is approximately 2 mm when the knee pad
CD
is at the stop position.
4) Securely tighten bolts ••• and
G.
5) Pressthe knee pad
CD
to raise the presser foot
e
by 14 mm; then move the knee lifter stop-
per. in the direction of the arrow so that it is
against the installation bracket projection ••
securely tighten the bolt •.