Installation; Installing The Rubber Hinge And The Corner Rubber; Insta Iiing The Oi I Pan; Installing The Machine Head - Consew 206RBL Instruction Manual

4.
INSTALLATION
4. INSTAllATION
A
CAUTION
,<;:\ •
Do not connect the power cord until instal-
\Y
lation is complete, otherwise the machine
will operate if the treadle is pressed by mis-
take, which could result in injury.
•• Be sure to connect the ground. If the ground
connection is not secure, serious electric
shocks will result.
,<;:\.
The sewing machine should only be in-
\Y
stalled by a qualified technician.
O.
Ask your SEIKO dealer or a qualified elec-
trician for any electrical work that may need
to be done.
O.
The sewing machine weights more than 29
kg. The installation should be carried out by
two or more people.
O·
Install the belt guard to the machine head.
4-1. Installing the rubber hinge and the corner rubber
1. Install the rubber hinge
e
on the table with nails
•. (Two places)
2. Install the corner rubber. at the four corners of
the table with nails
e.
4-2. Installing the oil pan
4-3. Installing the machine head
r
I
i
I
I
l~ __
I
I
I
I
Fit oil pan
0
into the opening in the table, and
secure it with 4 nails •.
(Refer to the work table processing diagram on
page 2.)
1. Insert the two bed hinge connections
0
into the
holes in the machine bed.
2. Fit the bed hinge connection
0
to the rubber hinge
• and then place the machine head onto the cor-
ner rubber
e.
3. Tap the head rest
0
into the table hole.
NOTE: Tap the head rest securely into the table
hole. If the head rest is not pushed in as
far as it will go, the machine head will not
be sufficiently stable when it is tilted back.
- 3-