Configuring Link Aggregation - AVT Bigeye G Installation Manual

Implementing link aggregation

Configuring Link Aggregation

Percentage of single port GigE bandwidth ~ 84%, LAG is not required to operate
the GX1050 camera at 100 fps in Mono8.
Example 2:
GX1050C using YUV422 pixel format and outputting 100 fps
Bandwidth usage = 1024 x 1024 x 2 (2 byte for YUV422) x 100
~ 210 MBps
Percentage of single port GigE bandwidth ~ 168%, LAG is required to operate
the GX1050C at 100 fps using YUV422.
The GX camera connected to host using LAG requires two host Ethernet adapter
ports. Configure and optimize each Ethernet adapter port using steps outlined
in Ethernet adapter configuration
setup of a link aggregate group.
[Windows 7, Intel PT]
– Start, Control Panel
– Hardware and Sound
– Device Manager
– Network Adapter
– Right-click Adapter device name
– Properties
– Teaming tab
– Select Team the adapter with other
adapters
– Click New Team
– The New Team Wizard window opens,
choose a team name and click Next
– Select the desired adapters corre-
sponding to the ports to be used by
the Prosilica GX camera, click Next
Figure 34: Team wizard adapter selection
on page 17. The following steps describe the
Figure 33: Intel adapter properties
teaming tab
AVT GigE Cameras Installation Manual V1.0.1
43