Using The Gige Sample Viewer; Launch The Application; Open Live View - AVT Bigeye G Installation Manual

Using the AVT viewer applications

Using the GigE Sample Viewer

Launch the application

Open live view

This section describes main features of GigE Sample Viewer.
Start the GigE Sample Viewer appli-
cation. Wait for the camera to
appear under Host.
If a camera does not appear after
some time, try the following:
• Confirm the camera is powered.
• Confirm the Ethernet cable is
connected to the host PC.
• Modify the Ethernet adapter
and/or Camera IP such that
they are on the same subnet.
For more information refer to
Modifying camera IP address
on page 35.
If the camera still does not appear, proceed to chapter
47.
Select the desired camera from the cameras window of the GigE Sample
Viewer. Click the eyeball icon. This opens a new view window. Using
default camera settings, this starts continuous acquisition from the
camera using freerun trigger mode.
If the images are too dark, point the camera directly at a light source to ensure
images are not being dropped. If no images appear proceed to
on page 47.
Figure 14: GigE Sample Viewer live view
Figure 13: camera window
Troubleshooting
AVT GigE Cameras Installation Manual V1.0.1
on page
Troubleshooting
30