Surface Controls Lock Feature - Kenmore Elite 790.4399 Series Use & Care Manual

front element and "0" will appear in the display. Touch
page 9) to connect bridge element and then touch
temperature desired. You may disconnect the bridge element at any time during
cooking by touching
simultaneously. A beep will be heard each time the pads are touched.
3. Start most cooking operations on a higher setting and then decrease to a lower
setting to finish cooking. Each surface element provides a constant amount of heat at
each setting. A glowing red surface heating area extending beyond the bottom edge
of the cookware indicates the cookware is too small. Please note that not all
cookware will fit the Bridge element correctly.
4. When cooking has finished on any of the surface elements, touch
OFF that element. The indicator(s) will flash "H" when the cooktop is ON but the
element is turned OFF indicating that the surface may be hot to the touch. The
flashing "H" indicator will turn OFF after 30 minutes or less.
To switch the entire cooktop OFF touch and hold the
will sound) and release. When the cooktop is powered OFF the "H" will glow steadily
indicating the cooktop may be hot to the touch. The "H" indicator will turn OFF after
30 minutes or less.
Note: The entire cooktop will automatically power OFF 10 seconds after all surface
elements have been turned OFF.
Note: See Recommended Surface Element Settings Table on page 9.

Surface Controls Lock Feature

It is possible to lock the surface element controls by touching and holding down on
pad for 2 seconds. One beep will sound and the Lock Indicator light will glow when
properly activated.
To unlock the surface elements touch and hold down
will sound and the Lock Indicator light will turn off.
pad. To instantly reset temperature to "0" touch
pad (See Figure 1, on
or pads to set the
pad to turn
pad for 2 seconds (a beep
pad for 2 seconds. One beep
10
Radiant
surface elements may
appear to have cooled
after they have been
turned off. "H" will appear
and
in the display and will
continue to glow for 30
minutes or less. The
glass surface may still
be hot and burns may
occur.