Mounting Your Bicycle To The Lemond Revolution; Bicycle Mounting Instructions - LeMond Revolution Service Manual

MOUNTING YOUR BICYCLE TO THE LEMOND REVOLUTION

R
Note: The LeMond
EVOLUTION
10-speed cassette. If your bike is equipped with a 9-speed Shimano®/SRAM® derailleur or Campagno-
lo® derailleur please follow the instructions on page 12 to change cassettes and/or cassette adapters.
If you are unsure about the type of derailleur installed on your bike please consult the documentation
for your bicycle or visit your local bike specialist to ensure proper compatibility with the
1. Shift the chain on your bicycle to the smallest sprocket on the rear cassette.
2. Open the rear brake calipers on your bicycle and remove the rear wheel.
WARNING: CONSULT THE MANUFACTURER'S DOCUMENTATION FOR YOUR BICYCLE OR YOUR
!
LOCAL BIKE SPECIALIST IF YOU ARE UNSURE ABOUT THE CORRECT PROCEDURE FOR REMOV
ING THE REAR WHEEL OF YOUR BICYCLE.
3. Loosen the quick-release axle on the
axle. Be sure to position the spacer properly based on the type of bicycle you are using. (See Figure 2.1)
Note: If you are using a time trial
R
bike with the
EVOLUTION
you will need to remove the
skewer completely to install
your bike.
4. With the rear wheel removed guide the rear of your bicycle over top of the
that the chain rests on the smallest sprocket of the cassette on the
stays rest on the axle of the
is shipped from the factory equipped with a Shimano®/SRAM® compatible
R
and locate the axle spacer on the fan side of the
EVOLUTION
Road Bike/ Time Trial Bike
R
. (Figure 2.2)
EVOLUTION

BICYCLE MOUNTING INSTRUCTIONS

Spacer Outside
Frame
Mountain Bike
R
EVOLUTION
R .
EVOLUTION
Spacer Inside
Frame
FIGURE 2.1
R
and ensure
EVOLUTION
and the bicycle chain
Chain on Smallest
Sprocket
Chainstays Resting
on Axle
FIGURE 2.2
9