Flywheel Installation Instructions - LeMond Revolution Service Manual

FLYWHEEL INSTALLATION INSTRUCTIONS

1. Slide the ywheel onto the shaft and rmly press it in place.
2. Place the at washer onto the shaft and start the nylock nut onto the shaft threads. (Figure 9.5)
3. Firmly hold the pulley and begin tightening the nylock nut. After the ywheel has started to press
onto the shaft hold the ywheel and nish tightening the nylock nut onto the shaft.
Note: There will be a fair amount of resistance while tightening the nut. Make sure that the ywheel is fully
seated onto the shaft and the nut cannot travel any further onto the shaft prior to operation.
4. Reinstall the 8mm E-clip onto the ywheel shaft. (Figure 9.6)
5. Spin the ywheel to ensure that rotation is true. If not, ensure that the nylock nut is as tight as pos-
sible.
6. Install the outer fan shroud onto the unit with the socket screws.
WARNING: DO NOT ATTEMPT TO OPERATE THE UNIT WITHOUT THE FAN SHROUD FULLY
!
INSTALLED.
FLYWHEEL REMOVAL AND INSTALLATION
FIGURE 9.5
FIGURE 9.6
23