Table of Contents
Advertisement
Safety hints
Apart from observing the general accident prevention regulations, the following
safety instructions must be observed to prevent life-endangering conditions,
damage and an increased accident hazard.
If leaks occur when pressure is applied, the pressure must be relieved
immediately. The leak must be sealed and defective components must be
replaced.
When repairs are made use original spare parts only. The unauthorised
replacement of damaged components with non-original spare parts is not
permitted.
All components must be handled exclusively as described in the
operating instructions and the general drawing. Changes to the
functional sequence or a different application are not allowed.
It must always check if the high-pressure hoses are connected correctly.
The high-pressure hoses must be laid such that they cannot be driven
over by vehicles or unnecessarily trodden by persons. Never lay hoses over
sharp objects (danger of cutting) and do not pinch or trap them.
Before the pressure is applied, the maximum working pressure (without
consumers) must be adjusted by an authorised person at the pressure-
limiting valve (Chap. Pressure adjustment).
The unit is not fitted with a safety valve. The maximum system pressure
of 2500 bar must never be exceeded.
Repairs must only be conducted when the system is depressurised and
disconnected from the power.
Verify the oil level before each commissioning.
You must carry protection eyeglasses while working with high-pressure
hydraulic aggregates.
In the case of use of a remote control, pay attention to electromagnetic
radiations.
Toll-Free: 866.345.8484 • Phone: 281.449.9994 • Fax: 281.449.9996 • Email:sales@titanti.com
TITAN Technologies International, Inc.
9001 Jameel Street, Suite 180 • Houston, TX 77040
http://www.titanti.com
®
Advertisement
Table of Contents
