Starting - Titan WindMaster 2010 Operating Manual

Starting

TITAN WindMaster
®
Note: The ™ 2010 Pump produces extremely high
hydraulic pressure. Extreme care must be taken to ensure safety.
Failure to do so may result in severe injury or death.
Before starting the work, please make sure that the oil level in the pump tank is
correct. The oil gauges should be filled with oil. Filling the tank approximately 1
cm under the tank caps is allowed. In some cases it can be necessary to refill the
device with oil.
Use only hydraulic oil and never aggressive oil, because it can results in
damaging your seals.
NOTE: CHECK AND ENSURE THAT THE APPLICATION AND ITS
THREADED FASTERNERS ARE SUITABLE FOR THE MAXIMUM
OPERATING PRESSURE.
HINT: ALSO, ONLY HOSES AND CONNECTIONS WITH SUITABLE
OPERATING PRESSURE RATINGAND SAFETY FACTORS SHOULD BE
USED. CHECK ALL HOSES FOR KINKING AND IF FOUND, REPLACE
PRIOR TO PRESSURIZING. FOR BEST RESULTS AND OPTIMUM SAFETY,
®
USE ONLY TITAN SUPPLIED HOSES, CONNECTIONS AND ACCESSORIES.
ATTENTION: NEVER USE THE HOSES AS A CARRING HANDLE.
The high-pressure hose must be shifted as straight-lined and directly as possible,
in each case never exceed the minimum bending radius. The hose should not be
overdriven or loaded. Sharp edged parts can damage the hose. Pay attention
particularly to the suitable threaded connections.
For tightening the threaded bolt or stud connection we recommend normal
spanners without extension, in order to avoid overloading at the threads. For the
hose connectors only use the threaded bolt or stud connections specified in our
catalogue under accessories.
Dirt particles in the hydraulic system can lead to damages at the cylinder faces
and at the valve seats, therefore replace dirty hydraulic fluid before starting.
After all components are examined for the structural integrity necessary for the
desired pressure, the device can be plugged in to the electricity supply. Turn the
main switch to the pos.1 to start the pump.
TITAN Technologies International, Inc. ®
9001 Jameel Street, Suite 180 • Houston, TX 77040
Toll-Free: 866.345.8484 • Phone: 281.449.9994 • Fax: 281.449.9996 • Email:sales@titanti.com
http://www.titanti.com